TMC LAB CNAS L8364 CMA 202119015835 Report Verification
TMC Forum
Industry Compliance

I left generous creepage and clearance on my PCB layout, so why do random units still fail the dielectric withstand test in production?

Design margins do not guarantee production stability; random hipot failures usually point to process defects rather than layout.

7 分钟读完 Industry Compliance
3 浏览

Why do random dielectric-withstand failures appear after production starts?

A common puzzle for hardware teams: the schematic passed review, the PCB layout carries generous creepage and clearance margins, and the pre-production samples earned a clean test report. Then mass production begins, and the dielectric withstand test occasionally trips on a few random units—fifty boards pass, the next ten suddenly fail. The issue is rarely whether the design spacing is adequate; it is whether the production unit still matches the designed unit.

First call: intermittent failures usually mean process-introduced weak points

Under IEC 62368-1 and GB 4943.1, the dielectric withstand test qualifies the actual sample’s insulation, not the dimension on the drawing. When the design spacing is already compliant, isolated failures in a batch typically trace back to assembly and process steps:

  • Solder residue: stray balls, splashes, or fragments of solder landing inside a spacing effectively build a temporary bridge between copper areas.
  • Coating defects: bubbles, missed spots, or uneven thickness in conformal coating re-expose creepage paths that were meant to be sealed.
  • Assembly stress: over-tightened screws warp the board or shift insulation sheets, shrinking the real gap below the design value.
  • Contamination and moisture: flux residue, shop dust, or handling oils form a leakage path once humidity rises.

The common trap: blaming the material

The first reflex—switching insulation material or thickening the board—usually misses the mark. These failures are characterized by being random, scattered, and reproducible on specific units, rather than systematically low across the whole batch. The right move is failure-point dissection of the tripping unit: inspect the trip location under magnification to see whether it is solder bridging or a coating void, and the cause usually becomes obvious.

Symptom Likely root cause Action
Repeated trips at one spot Marginal design spacing or placement Re-check creepage and clearance at that path
Random scattered trips Process residue, coating, or contamination Dissect the failed unit, trace the process step
Clustered trips after humidity Coating or storage environment Verify coating completeness and humidity control

Conclusion

Intermittent hipot failures are not a reason to redesign. Treat drawing-compliant and production-compliant as two separate things: leaving adequate spacing at design stage is the baseline, but holding process consistency in production is what keeps the test stable. We recommend dissecting first-article and periodic failed units to build traceability from process step to failure location—more economical and more root-cause-focused than blindly thickening the board.

TMC Maike Testing | CNAS Accredited Laboratory (L8364) | CMA Accreditation
Shenzhen Bao’an + Dongguan dual bases · 10000 sqm laboratory | Serving 100+ countries worldwide
13510907826 | cert@tmc-lab.com

文中涉及的测试项目均可委托 TMC LAB 执行。把产品和目标市场发给我们,可得到针对性的测试清单。

返回内容中心

标准看得懂,项目才做得对

把标准号和产品发给我们,技术顾问用工程语言讲清楚要做哪几项、为什么。

Discussion

读者评论 0

还没有评论,来说两句吧。

发表评论

Call